New tool in the shop.
He had been running this 3D printer pretty much non stop for a couple days. He had just about used 1000 meters of filament and thinks he has just about got it dialed in. If you are needing anything, he is ready to take orders!
Currently he has black, and white material, but he can get pretty much any color (or close) in a day or two.
Things that will be printing next week;
Frag plugs (cause we can)
Frag rack (see below)
Magnet holder for frag rack (I have been so worried about rusting, now I can seal them up!)
Seahorse hitching/feeding tube station
Probe holder
Dosing line holder
Nori feeding bracket
He isn't a huge fan of suction cups, especially when holding up hundreds of dollars of coral, but this has been on the white board for about 15 minutes when the photo was taken...not bad
Brackets will hold standard eggcrate. He will be taking some of these to the MAST meeting on February 6 (the weekend meeting/show) and they will be available at his table.
Magnetic frag rack holder done!
The magnets are sealed in a housing, so they won't rust. This one is on a 3/8" piece of acrylic, and not falling off. I am going to see if I can make one stronger for thicker tanks.
He had been running this 3D printer pretty much non stop for a couple days. He had just about used 1000 meters of filament and thinks he has just about got it dialed in. If you are needing anything, he is ready to take orders!
Currently he has black, and white material, but he can get pretty much any color (or close) in a day or two.
Things that will be printing next week;
Frag plugs (cause we can)
Frag rack (see below)
Magnet holder for frag rack (I have been so worried about rusting, now I can seal them up!)
Seahorse hitching/feeding tube station
Probe holder
Dosing line holder
Nori feeding bracket
He isn't a huge fan of suction cups, especially when holding up hundreds of dollars of coral, but this has been on the white board for about 15 minutes when the photo was taken...not bad
Brackets will hold standard eggcrate. He will be taking some of these to the MAST meeting on February 6 (the weekend meeting/show) and they will be available at his table.
Magnetic frag rack holder done!
The magnets are sealed in a housing, so they won't rust. This one is on a 3/8" piece of acrylic, and not falling off. I am going to see if I can make one stronger for thicker tanks.