So this is really bugging me.
I am having an issue with my ATO connected to my breakout box. When i first installed it the Apex base unit the apex would not recognize it and the SW1 would not activate if i moved the float for open/closed. (I know it doesn't show up like other modules)
So i had to install it on my PM2 module. I got it to recognize it on the PM2 and the switch will go open/ closed as it should if i remove water, It works for a short time then all of a sudden the pump will not come on when the switch closes or the pump will come on and not turn off if the switch is open. I originally had it in plug 7 but changed it to plug 8 thinking this was the issue as 4 and 8 are best for low wattage hardware. It did not fix the issue. I have tried different terminals on the breakout box. (like spot 2 and 3)
Am i supposed to configure the plug outlet itself or does it have to be a virtual outlet? I wonder if it is a bad breakout box
My programing is below.
(PM2 name for it is SWX4_1 and SWX4_2)
Fallback OFF
Set OFF
If SWX4_1 OPEN Then OFF
If SWX4_1 CLOSED Then ON
If SWX4_2 OPEN Then OFF
Defer 004:00 Then ON
I am having an issue with my ATO connected to my breakout box. When i first installed it the Apex base unit the apex would not recognize it and the SW1 would not activate if i moved the float for open/closed. (I know it doesn't show up like other modules)
So i had to install it on my PM2 module. I got it to recognize it on the PM2 and the switch will go open/ closed as it should if i remove water, It works for a short time then all of a sudden the pump will not come on when the switch closes or the pump will come on and not turn off if the switch is open. I originally had it in plug 7 but changed it to plug 8 thinking this was the issue as 4 and 8 are best for low wattage hardware. It did not fix the issue. I have tried different terminals on the breakout box. (like spot 2 and 3)
Am i supposed to configure the plug outlet itself or does it have to be a virtual outlet? I wonder if it is a bad breakout box
My programing is below.
(PM2 name for it is SWX4_1 and SWX4_2)
Fallback OFF
Set OFF
If SWX4_1 OPEN Then OFF
If SWX4_1 CLOSED Then ON
If SWX4_2 OPEN Then OFF
Defer 004:00 Then ON